microcontroller
美英 [maɪkrəʊkɒnt'rəʊlər]
- n.微控制器；微型控制器
- 网络单片机；微处理器；微控器
microcontrollermicrocontroller
微控制器
微控制器（MicroController）又可简称MCU或μC，也有人称为单芯片微控制器（Single Chip Microcontroller），将ROM、RAM …
单片机
单片机（Microcontroller）一般都有内部ROM/EEPROM/Flash供用户存放程序。为了防止未经授权访问或拷贝单片机的机内程 …
微型控制器
电梯专业英语词汇（三） ... micro-computer 微型计算机 microcontroller 微型控制器 microfarad 微法 ...
微处理器
微处理器(microcontroller)上要附有温度感测 。
微控器
微控器(Microcontroller),而非微处理机 (Microprocessor)¸¸¸指令集共包含111个指.. 全部>> 骊威也不错 分享于 2009-03-02 14:54 …
单片微控制器
单片微控制器(Microcontroller)又称为单片微型计算机(Single-Chip Microcomputre或One-Chip Microcomputre)，我国普遍采用 …
1
A microcontroller is often small and low cost. The components are chosen to minimize size and to be as inexpensive as possible.
一个微控制器通常很小，并且成本很低。组件的大小是越小越好，价格越低越好。
2
MCS-51 microcontroller which is all typical and representative of a widely used in various fields.
其中51单片机是各种单片机中最为典型和最有代表性的一种，广泛应用于各个领域。
3
Mainly used for transistor output characteristic curve for data collection, controlled by a microcontroller, into the PC, for display.
主要用于对晶体管输出特性曲线进行数据采集，由单片机进行控制，送入PC机进行显示。
4
To increase the accuracy of the system, a calibration or conditioning algorithm must be programmed into the microcontroller.
为了增加系统，校准或调节算法精度必须被编程到微控制器。
5
Master in part by the microcontroller and keyboard of two parts, shown in part by the LCD display module and LED work analog parts.
主控部分是由单片机和键盘两部分构成，显示部分是由LCD显示模块和LED工作模拟部分构成。
6
The accomplishment of this microcontroller can settle a strong base to design other ASICs and implement system integration.
本微控制器的设计完成可以为将来开发具有特殊用途的专用集成电路以及实现系统集成奠定坚实的基础。
7
In microcontroller serial port communication, the system require that the baud rate of dispatcher and sink should keep consistent.
在单片机串行通信中，要求发送和接收的波特率保持一致。
8
The microcontroller reads the state of a pin through the Pin value line, and writes though the latch value line.
微控制器读取通过引脚值线引脚的状态，并写入锁存尽管价值线。
9
The microcontroller and computer can easily communicate through serial port, thus the system can be controlled by user with computer.
单片机和上位机之间通过串口通信，可以用计算机操纵整个系统。
10
CAN controllers with object storage are designed to take as much strain as possible off the local microcontroller.
能与对象存贮的控制器被设计采取同样多张力尽可能地方微型控制器。
11
Finally, it would need to accomplish all of these tasks under the control of a software program running the microcontroller chip.
最后，需要在微处理器芯片上运行软件编程控制来完成所有这些任务。
12
Thedownloading program receives the new application program and loads it into a readonly memory external to the microcontroller.
装载程序接收新的应用程序并存储到单片机的外部ROM中。
13
In secondary circuit, the microcontroller receives command signals to control the rotation direction of implanted electric knuckle.
次级单片机接收命令信号，控制植入电动关节的旋转方向。
14
The hardware and software designing of a microcontroller system supplied by energy transmitted through optical fiber is described.
介绍以光纤传输的能量供电的微控制器系统的软硬件设计。
15
The small footprint module adds an OPC-UA Server to any product via an integrated RJ-45 Ethernet interface and ARM microcontroller.
通过将RJ-45以太网接口和ARM微处理器相结合，小尺寸模块将OPC-UA服务器增加到任何一个产品中。
16
A basic data path configuration capable of processing the microcontroller basic instruction set was developed first.
一个根底数据途径可以对被设定的微节制器根本指令告状的设置装备摆设是起首开展。
17
If the input dimming comes from a microcontroller, the power from the AC line needs to be appropriately managed.
如果用微控制器进行输入调光，那么必须对AC线路电力加以适当管控。
18
Each 12-battery module contains a PC board with an LTC6802, a microcontroller, a CAN interface, and a galvanic isolation transformer.
每个由12个电池组成的模块都含有一个PC板，板上有1个LTC6802、1个微控制器、1个CAN接口和1个电流隔离变压器。
19
Basically, any product or device that interacts with its user has a microcontroller buried inside.
基本上，任何能够与使用者互动的产品或设备，其中都埋入了微控制器。
20
Since each LED is only supposed to be on one at a time , we can drive the whole array pretty easily, and directly from the microcontroller.
由于每个LED在一个时刻只亮一盏，我们可以轻而易举地直接由微型驱动器驱动整排LED。
21
The design of receiver module includes the one of radio frequency receiver, microcontroller and human-machine interaction.
接收器模块的设计包括射频接收电路设计、控制器单元设计和人机交互能力设计。
22
The status of the pin of the microcontroller depends upon values of the DDR bit, the port bit, and its external connection.
微处理器的管脚状态依靠DDR位的值、端口位和其外部连接。
23
Inother words the microcontroller is not a standard component and this increases its cost of manufacture.
换而言之，单片机不是标准器件，这就增加了生产成本。
24
With the combining of this PWM generator and microcontroller, sine wave inverter at high temperature is prepared.
该PWM发生器与微控制器密切配合，实现了高温正弦逆变。
25
Also the program counter keeps track of which command is to be executed by the microcontroller .
程序计数器也通过微控制器掌握要执行哪条命令。
26
Most microcontroller applications, more comprehensive.
单片机大多数应用，比较全面。
27
The integration of power and analog elements with a CMOS microcontroller unit (MCU) has been possible for several years.
电力供应与带有互补金属氧化物半导体的微控制器单元的模拟要素的整合已经可用了数十年了。
28
Using a dedicated high-speed magnetic sensors with microcontroller (MCU) electronic compass can effectively solve these problems.
本系统采用专用的磁场传感器结合高速微控制器（MCU）的电子指南针能有效解决这些问题。
29
This system uses a hierarchical, modular design, the entire system consists of data acquisition systems, microcontroller control system.
本系统采用层次化、模块化设计，整个系统由数据采集系统、单片机控制系统组成。
30
Design steps, implementation and testing of all the microcontroller development circuits are shown graphically and explained in detail.
计划步调，施行和检验一切的微节制器开展电路图解式地被显现而且细致地注释。