adiabatic
美 [ˌædɪə'bætɪk]英 [ˌædɪə'bætɪk]
- adj.【物】绝热的;不传热的
- 网络绝热层厚;绝热式;绝热曲线
adiabatic
adiabatic
绝热的
汽车专业英语词汇_百度文库 ... Adhesive 黏合剂 Adiabatic 绝热的 Adiabatic compression 绝热压缩 ...
不传热的
航海及海运专业英语词汇(A2) ... adiabatic wall temperature 绝热壁温 adiabatic 不传热的 adiabatic 绝热的 ...
绝热层厚
辽阳盛旺化工设备制造有限公司 ... 工作压力 Working 绝热层厚 adiabatic 外形尺寸(直径×高) Dimensions ...
绝热式
然而,绝热式(adiabatic)光方向完全耦合器具有对光极化,光波长以及元件长度不敏感特性,所以针对於此本研究探讨如何在低 …
绝热曲线
是否是绝热特性的
FDS命令集合 - 月风的日志 - 网易博客 ... TMP_INNER 内部温度 ADIABATIC 是否是绝热特性的 .FALSE. 字符串 ...
1
The dynamic process for the quantum information storage and that of the recall with the photon echo is discussed under adiabatic condition.
探讨了绝热条件下光子回波技术对量子信息存储和信息提取的动态过程。
2
Finally, air entrained from or released into a confined adiabatic bubble will appropriately influence the pressure and volume of the bubble.
最后,空气使乘火车从或进入泡沫将会适当地影响压力和泡沫的音量被限制的绝热之内发表。
3
By the method of adiabatic theorem, this paper studies the semiclassical quantization of a chaotic state for a coupled system.
运用绝热定理的方法研究耦合系统混沌态的半经典量子化。
4
In an adiabatic process no heat is allowed to enter or leave the system.
在绝热过程中,不容许热量进入或离开系统。
5
With the rotational speed increasing, the total pressure ratio of the ram-rotor rises, but the adiabatic efficiency decreases.
随着转速的增加,旋转冲压压缩转子三维进气流道的增压比不断提高,而其绝热效率却不断降低;
6
This expansion takes energy from the air, resulting in temperature reduction, a process known as adiabatic cooling.
此膨胀吸收了空气中的能量,导致空气温度下降,这个过程称为绝热冷却。
7
Our constraint is going to be an adiabatic expansion or compression.
现在约束改成了,绝热膨胀,或者压缩。
8
It follows that every reversible adiabatic process is one of constant entropy , and may be described as isentropic .
定律认为熵,是一个衡量系统紊乱的方法,这个量会一直增加。
9
This article deals with output regulation of an adiabatic tubular reactor by virtue of a single manipulated input.
本文探讨在单一操作变数下处理绝热管式反应器的输出规则。
10
Adiabatic means there's no heat transferred in or out of the system.
绝热意味着系统,与化境没有热交换。
11
Rock wool board products used in industrial equipment, building, ships of adiabatic, sound insulation, etc.
岩棉板产品适用于工业设备、建筑、船舶的绝热、隔音等。
12
The thermal damping is maximum for frequencies corresponding to pulsations that are somewhere between isothermal and adiabatic.
当脉动处于等温和绝热之间某个状态时,相应频率下的热阻尼是最大的。
13
It's set up to be well-insulated so it's adiabatic.
所以它是绝热的。
14
The flow of heat requires finite time, so any process performed quickly enough will be practically adiabatic.
因为热流需一定的时间,所以足够快速进行的任一过程实际上都是绝热的。
15
the numerical simulation accuracy of adiabatic shear bands needs to be improved.
绝热剪切数值模拟精度有待提高等。
16
So your time scale it just fast enough that this is basically an adiabatic compassion.
你的时间足够快以至于,基本上是一个绝热过程。
17
Has the advantages, adiabatic, fire prevention, high temperature resistance, ageing resistance, bibulous rate is lower notable features.
具有轻质、绝热、防火、耐高温、耐老化、吸水率低等显著特点。
18
The benefits of adiabatic humidification can be extremely effective in many cases.
绝热加湿的好处,可以非常有效的在许多情况下。
19
In an adiabatic system, this heat release serves to increase the chamber temperature.
在一绝热系统中,放出的热量增加了燃烧室的温度。
20
Quantum adiabatic approximation is widely used in quantum physics.
量子绝热近似在量子物理学中有着广泛的应用。
21
Energy recovery threshold logic (ERTL) is proposed, which combines threshold logic with adiabatic approach.
提出了能量回收阈值逻辑电路(ERTL)。
22
The adiabatic conditions affects the formation, development and structure change of the vortex the most.
绝热条件对低涡形成、发展及结构变化的影响最为显著;
23
A ratio of strength to thermal conductivity is proposed to characterize the adiabatic shearing sensitivity for steels.
提出用钢的强度与热导率的比值来表征钢的绝热剪切敏感性。
24
Application of static fuel management codes for determination of the neutron noise using the adiabatic approximation.
静态燃料管理编码在用绝热近似测定中子噪声中的应用…[中国核科技信息与经济研究院]。
25
In addition, the wall temperature in the adiabatic section fluctuates regularly and periodically under the steady working conditions.
振荡热管稳定运行时,绝热段各管管壁温度波动是有规律、周期性的。
26
Research was conducted on characteristics of adiabatic shear bands (ASBs) in several steels by contained exploding cylinder technology.
研究了几种不同硬度和热导率的钢铁材料在约束爆破条件下的绝热剪切带特征。
27
The optimized rotor can evidently enhance the adiabatic efficiency and has fine off-design performance.
优化后叶片绝热效率有较大程度的提高,并且具有良好的变工况性能。
28
The determination of throttle coefficient of real gas in adiabatic throttle process is discussed in this paper.
讨论了实际气体绝热节流系数的计算,节流系数可用计算法和作图法来确定。
29
Then, evolvement laws of plasma in both isothermal stage and adiabatic expansion stage are discussed.
进而讨论了等离子体膨胀的绝热阶段和等温阶段的具体演化规律。
30
The temperature rise near explosive welding interface is caused by explosive adiabatic compression and abnormal energy deposition.
爆炸焊接界面附近温升是由爆炸绝热压缩和畸形变形能沉积两者造成的。