sem

  • abbr.(=scanning electron microscope)扫描电子显微镜
  • 网络扫描电子显微镜(scanning electron microscope);扫描电镜;搜索引擎营销(Search Engine Marketing)

semsem

sem

扫描电子显微镜(scanning electron microscope)

扫描电子显微镜sEM)下其界面1个月可见骨质形成,4个月可见完整的层板状骨附于其界面。由于良好的骨引导作用,种植 …

扫描电镜

扫描电镜(Sem)压力与我(除了纽约85式的dj混合)htttp://www.fcc18.com/up/wma/index.php?929fd242-9c6a-11e0-a111-0015c55…

搜索引擎营销(Search Engine Marketing)

搜索引擎营销观察(SEMWatch.org)是专注搜索引擎营销SEM)的群体博客,关注 SEM / SEO 领域的最新行业动态,产品 …

扫描式电子显微镜

扫描式电子显微镜(sem)所见,像 癫痫刀高性能电子显微镜,血液 癫痫刀高性能电子显微镜,血液 他们用细胞培养及电子显微镜观 …

结构方程模型(Structural Equation Modeling)

结构方程模型SEM)是一种多元分析技术,它包含标准的方法,并在标准方法的基础上进行了扩展。这些方法包括回归技术 …

1
SEM micrographs indicate that there existed perfect interfacial adhesion between the surface layer and the substrate one. 对过渡层研究结果表明,复合面层与混凝土基材间的粘接性优异。
2
It was found that there was no reaction between coating layer and aggregate through SEM studies on interfacial transition zone. 通过扫描电镜观察再生粗骨料的界面过渡区,发现涂浆层不与骨料本身反应。
3
SEM observation suggested that the wear mechanism of FEP coatings appeared to be obvious fatigue wear at relatively high temperatures. 在较高的环境温度下,涂层的磨损呈现出明显的疲劳磨损特征。
4
The microstructure of the welding joint was analyzed by SEM, and its corrosion property was tested by an electrochemical system. 利用扫描电镜分析焊接接头微观组织;电化学系统测试接头各区腐蚀速率;
5
The surface morphology of the films were observed by Scan Electron Microscope (SEM) and Atom Force Microscope (AFM) respectively. 用扫描电镜、原子力显微镜观测了非连续多层膜的表面形貌。
6
The surface morphology of the polymer film was examined by scanning electron microscopy (SEM) and atomic force microscopy (AFM). 高分子膜的表面形态采用扫描电子显微镜(SEM)和原子力显微镜(AFM)进行检查。
7
One of each group was remained for veneering porcelain at the end of it, and was observed with SEM and energy spectrum analysis. 3. 每组各留一个试件,上瓷时将瓷烤在金属试件的末端以做扫描电镜和能谱分析。
8
Methods To identify the holistic morphology and the surface ultrastructure characteristic of seeds by scanning electron microscope(SEM). 方法采用扫描电镜观察三种种子的整体形态和种皮表面超微结构特征。
9
STEM and SEM investigations confirm the location of these metal particles is only inside the carbon nanotubes. 使用扫描电镜和扫描透射电镜研究证实金属粒子仅存在于纳米碳管内部。
10
This paper has analyzed the surface and cross-section morphology and the phase composition of the ceramic coatings by using SEM, XRD. 采用SEM、XRD等方法对陶瓷膜的表面微观形貌、结构及成分进行了表征。
11
SEM observation shows that the crystals by pulse current are smaller and the surface is smoother than that of by direct current. 脉冲镀层比直流镀层的结晶更细密,表面更光滑平整。
12
The surface appearance and corrosion products of Zn-Mg alloy coatings with different content of Mg were analyzed by SEM and XRD. 采用扫描电镜和X射线粉末衍射,对含镁量不同的热镀锌镁合金镀层表面形貌和腐蚀产物进行了分析。
13
The body size of leptophlebiid mayflies are usually very small, many microscopical and SEM structures have been employed in previous work. 细裳蜉科蜉蝣个体较小,对本科的研究又相对较深入,很多情况下要用到极细微结构特征。
14
The fracture analysis was made by means of microstructure, macrostructure, SEM, chemical composition, stress measurement and calculation. 采用宏、微观、扫描电镜、化学分析、应力测定及计算等方法对断裂螺母进行了分析。
15
The results of SEM and EDS analysis indicate that Ni-Co could be plated on the surface of cenospheres comparatively homogenous. 扫描电镜和能谱分析表明镍钴合金被均匀地施镀到了微珠表面。
16
The heat aging properties of rigid PVC are studied by means of mechanical properties test, SEM and FT-IR. 采用力学性能测试、扫描电镜、红外光谱(FT-IR)等方法研究了硬质聚氯乙烯的热老化性能。
17
In this study, the low-loss electron (LLE) method in the SEM was applied to CMP samples at close to a right angle to the beam. 在这项研究中,低损耗电子(阿勒)在扫描电镜方法应用于中医样本接近直角的光束。
18
SEM result indicates that the mycelium on the surface of ectoblast of Nocardia cell is the important attachable site. 扫描电镜检测结果表明,诺卡氏菌细胞表面的菌丝是重要的吸附部位;
19
The fracture reason of high temperature fixture was analyzed by means of metallographic examination, SEM and chemical composition analysis. 采用金相检验、扫描电镜观察和化学成分分析等方法对万能材料试验机高温卡具断裂原因进行分析。
20
SEM images show that the surface of the microsphere was not smooth, and the inside was loosen. 扫描电镜照片显示,微球的表面并不圆滑,内部为疏松的网络结构。
21
The obtained silver nanoparticles were characterized by means of powder X-ray diffraction (XRD) and scanning electron microscope (SEM). 并用X射线衍射(XRD)和扫描电子显微镜(SEM)对所得银纳米杜子进行表征。
22
The cracked longitudinal beam of a coach was analysed by means of metallography and SEM . 用金相、扫描电镜等分析方法,对开裂的客车纵梁进行了分析。
23
Through analyses carried out with SEM, tool failure patterns under different cooling and lubricating modes were studied. 借助扫描电镜的检测手段,研究了不同冷却润滑条件下刀具的失效形式。
24
And the result of the SEM indicated that job burnout played a mediating effect between occupational stress and depression symptoms. 结构方程模型分析结果显示,职业倦怠在职业紧张和抑郁的关系中起到了中介作用。
25
The morphology, status, chemical state & properties of the composite deposits were studied by means of SEM, TEM and XRD. 利用SEM,TEM,XRD等方法研究了复合镀层的组织、结构、性能及其影响因素。
26
Au nanoparticles were characterized by means of scan electron microscope (SEM), scan probe microscope (SPM) and X-ray diffraction (XRD). 利用扫描探针显微镜、扫描电子显微镜和X射线衍射等技术对制备的金胶体进行表征。
27
SEM is an important means for the observation and study of the artificial opal photonic crystal. 扫描电子显微镜是对人工欧泊光子晶体进行形貌观察、研究的重要手段。
28
Results: SEM is a Synthetic thinking and analytic approach. It has its own particular advantage but several deficiencies. 结果:结构方程是一种综合思维方法,有着其独有的优势,也具有一定的局限性。
29
The analysis by SEM showed that the salt slurry changed the micro-appearance of the desulphurization agent particles. 通过SEM分析发现,盐泥使固硫剂颗粒的表面微观形貌发生改变。
30
The film-forming situation of the product compounds on the surface of the steel sheet was observed by SEM. 用SEM技术观察产物化合物在钢片表面的成膜情况,参照文献对其进行复配。